Samsung Z2 Z200FDDU0BPL2 Firmware
Samsung Z2 Z200FDDU0BPL2 is an Android 5.1.1 firmware for India (INS). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build Z200FDDU0BPK3: Android updated from Android 6.0.1 to Android 5.1.1. A newer build for SM-Z200F is available: Z200FDDU0BQL1.
8.9/10 (497)4,214 times
Android 5.1.1
OS Version
2016-11-18
Build Date
n/a
Security patch
1
Countries
1
CSC codes
0
Bootloader binary
Bootloader binary 0. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: Z200FDDU0BPL2
How to flash Z200FDDU0BPL2
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- Z200FDDU0BPL2 has bootloader binary 0. Your device must run binary 0 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
Z200FDDU0BPL2 is Android 5.1.1 firmware for Samsung Z2, released for India (INS). Samsung built it on 2016-11-18.
No. A newer build for SM-Z200F is available: Z200FDDU0BQL1. Install it instead of Z200FDDU0BPL2 unless you need this exact version. The previous build was Z200FDDU0BPK3.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Z2 must be on bootloader binary 0 or lower.
This build uses bootloader binary 0. It can be flashed on a Samsung Z2 running binary 0 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 9 other builds of this model use the same binary, so you can switch between them in both directions.