Samsung Galaxy S4 Zoom C101XXUBND4
SM-C101 https://samfirm.shop/model/SM-C101 1 country Android 4.4.2 (KitKat)

Samsung Galaxy S4 Zoom C101XXUBND4 Firmware

Samsung Galaxy S4 Zoom C101XXUBND4 is an Android 4.4.2 (KitKat) firmware for Philippines (GLB). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build C101ZNUANL1 https://samfirm.shop/build/C101ZNUANL1: Android updated from Jelly(Android Bean) to Android 4.4.2 (KitKat). A newer build for SM-C101 is available: C101XXUBPA1 https://samfirm.shop/build/C101XXUBPA1.

Download firmware
9.1/10 (457)4,356 times
Android 4.4.2 (KitKat)
OS Version
1
Countries
1
CSC codes
U (30)
Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: C101XXUBND4
    ModelRegionCSC VersionSizeFile nameDownload
    SM-C101
    GLB Philippines
    C101OLBBND1 — —

    No matching downloads

    How to flash C101XXUBND4

    • C101XXUBND4 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Device specifications

    • Launched withAndroid 4.2
    • Display diagonal10.9 cm (4.3")
    • Display resolution540 x 960 pixels
    • Display typeSAMOLED
    • Processor frequency1.5 GHz
    • Rear camera resolution16 MP
    • Rear camera typeSingle camera
    • SIM cardsSingle SIM
    • Battery capacity2330 mAh
    • Weight208 g

    Frequently Asked Questions

    C101XXUBND4 is Android 4.4.2 (KitKat) firmware for Samsung Galaxy S4 Zoom, released for Philippines (GLB).

    No. A newer build for SM-C101 is available: C101XXUBPA1. Install it instead of C101XXUBND4 unless you need this exact version. The previous build was C101ZNUANL1.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S4 Zoom must be on bootloader binary U (30) or lower.

    This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy S4 Zoom running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 33 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy S4 Zoom

    https://samfirm.shop/build/C101XXUBPA1
    No changelog details available.