SM-F776N 1 country Android 17

Samsung Galaxy Z Flip8 F776NKSU2AZJC Firmware

Samsung Galaxy Z Flip8 F776NKSU2AZJC is an Android 17 firmware for South Korea (KOO, KTC, LUC, SKC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build F776NKSU2AZJ8, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. This is the newest build for SM-F776N.

Download firmware
9.1/10 (22)352 times
Android 17
OS Version
2026-10-28
Build Date
1
Countries
4
CSC codes
2
Bootloader binary

Bootloader binary 2. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: F776NKSU2AZHJ
    ModelRegionCSC VersionSizeFile nameDownload
    SM-F776N
    KOO, KTC, LUC, SKC South Korea
    		F776NOKR2AZJC 16.644 GiB
    SM-F776N_80_20261028181821_ul4s63j5tp_fac.zip
    		Download

    No matching downloads

    How to flash F776NKSU2AZJC

    • F776NKSU2AZJC has bootloader binary 2. Your device must run binary 2 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Device specifications

    • Display diagonal17.5 cm (6.9")
    • Display resolution2520 x 1080 pixels
    • RAM12 GB
    • Rear camera resolution50 MP
    • Rear camera typeDual camera
    • Battery capacity4300 mAh
    • Weight180 g

    Specifications of SM-F776B, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.

    Frequently Asked Questions

    F776NKSU2AZJC is Android 17 firmware for Samsung Galaxy Z Flip8, released for South Korea (KOO, KTC, LUC, SKC). Samsung built it on 2026-10-28.

    Yes. F776NKSU2AZJC is the newest build for SM-F776N on SamFirm. The previous build was F776NKSU2AZJ8.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 16.644 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Z Flip8 must be on bootloader binary 2 or lower.

    This build uses bootloader binary 2. It can be flashed on a Samsung Galaxy Z Flip8 running binary 2 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 5 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Z Flip8

    No changelog details available.
    Model firmware by region

    New firmware for other devices

    All latest builds