Samsung Galaxy Core Prime G360TUVU1AOF8 Firmware
Samsung Galaxy Core Prime G360TUVU1AOF8 is an Android 5.1.1 (Lollipop) firmware for United States (TMB). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SM-G360T is available: G360TUVU2AQD1.
8.9/10 (451)4,352 times
Android 5.1.1 (Lollipop)
OS Version
2015-06-20
Build Date
n/a
Security patch
1
Countries
1
CSC codes
1
Bootloader binary
Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy Core Prime use bootloader binary 2 (latest: G360TUVU2AQD1). If your device already runs binary 2, this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: G360TUVU1AOF8
Device specifications
- Launched withAndroid 5.1
- Display diagonal11.4 cm (4.5")
- Display resolution480 x 800 pixels
- Processor frequency1.2 GHz
- RAM1 GB
- Rear camera resolution5 MP
- Rear camera typeSingle camera
- Battery capacity2000 mAh
How to flash G360TUVU1AOF8
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- G360TUVU1AOF8 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
G360TUVU1AOF8 is Android 5.1.1 (Lollipop) firmware for Samsung Galaxy Core Prime, released for United States (TMB). Samsung built it on 2015-06-20.
No. A newer build for SM-G360T is available: G360TUVU2AQD1. Install it instead of G360TUVU1AOF8 unless you need this exact version.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Core Prime must be on bootloader binary 1 or lower.
This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy Core Prime running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 3 other builds of this model use the same binary, so you can switch between them in both directions.