Samsung Galaxy S5 G900FDXS1BPE3 Firmware
Samsung Galaxy S5 G900FDXS1BPE3 is an Android 5.0 (Marshmallow) firmware for Thailand (THL). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build G900FXXS1BPE3: Android updated from Android 5.0 (Lollipop) to Android 5.0 (Marshmallow). A newer build for SM-G900F is available: G900FXXS1PPCG.
8.7/10 (452)4,382 times
Android 5.0 (Marshmallow)
OS Version
2016-05-12
Build Date
n/a
Security patch
1
Countries
1
CSC codes
1
Bootloader binary
Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: G900FDXS1BPE3
Device specifications
- Display diagonal12.9 cm (5.1")
- Display resolution1920 x 1080 pixels
- Display typeSAMOLED
- Processor frequency2.5 GHz
- RAM2 GB
- Rear camera resolution16 MP
- Rear camera typeSingle camera
- SIM cardsSingle SIM
- Battery capacity2800 mAh
- Weight145 g
How to flash G900FDXS1BPE3
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- G900FDXS1BPE3 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
G900FDXS1BPE3 is Android 5.0 (Marshmallow) firmware for Samsung Galaxy S5, released for Thailand (THL). Samsung built it on 2016-05-12.
No. A newer build for SM-G900F is available: G900FXXS1PPCG. Install it instead of G900FDXS1BPE3 unless you need this exact version. The previous build was G900FXXS1BPE3.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S5 must be on bootloader binary 1 or lower.
This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy S5 running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 289 other builds of this model use the same binary, so you can switch between them in both directions.