EK-GC100 1 country Android 4.1.2 (Jelly Bean)

Samsung Galaxy Camera GC100ZSBMC1 Firmware

Name: Samsung Galaxy Camera (EK-GC100)
Brand: Samsung
Availability: InStock

Samsung Galaxy Camera GC100ZSBMC1 is an Android 4.1.2 (Jelly Bean) firmware for Taiwan (BRI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build GC100ZSBMB1: Android updated from Jelly(Android Bean) to Android 4.1.2 (Jelly Bean). A newer build for EK-GC100 is available: GC100XXBME1.

9.2/10 (472)4,383 times

Android 4.1.2 (Jelly Bean)

OS Version

2013-04-23

Build Date

n/a

Security patch

Countries

CSC codes

S (28)

Bootloader binary

Bootloader binary S (28). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy Camera use bootloader binary X (33) (latest: GC100XXBME1). If your device already runs binary X (33), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: GC100XXBMC3

Model	Region	CSC Version	Release date	Size	File name	Download
EK-GC100	BRI Taiwan	GC100OZSBMBC1	2013-05-03	—	—

How to flash GC100ZSBMC1

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

GC100ZSBMC1 has bootloader binary S (28). Your device must run binary S (28) or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

GC100ZSBMC1 is Android 4.1.2 (Jelly Bean) firmware for Samsung Galaxy Camera, released for Taiwan (BRI). Samsung built it on 2013-04-23.

No. A newer build for EK-GC100 is available: GC100XXBME1. Install it instead of GC100ZSBMC1 unless you need this exact version. The previous build was GC100ZSBMB1.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Camera must be on bootloader binary S (28) or lower.

This build uses bootloader binary S (28). It can be flashed on a Samsung Galaxy Camera running binary S (28) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.