Samsung GALAXY ACE 3 I679KEUANA6
SCH-I679 1 country Android 4.3 (Jelly)

Samsung GALAXY ACE 3 I679KEUANA6 Firmware

Samsung GALAXY ACE 3 I679KEUANA6 is an Android 4.3 (Jelly) firmware for China (CTC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SCH-I679 is available: I679KEUAOI1.

Download firmware
9.3/10 (455)4,396 times
Android 4.3 (Jelly)
OS Version
1
Countries
1
CSC codes
U (30)
Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: I679KEUANA6
    ModelRegionCSC VersionSizeFile nameDownload
    SCH-I679
    CTC China
    		I679CTCANA6 — —

    No matching downloads

    How to flash I679KEUANA6

    • I679KEUANA6 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    I679KEUANA6 is Android 4.3 (Jelly) firmware for Samsung GALAXY ACE 3, released for China (CTC).

    No. A newer build for SCH-I679 is available: I679KEUAOI1. Install it instead of I679KEUANA6 unless you need this exact version.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung GALAXY ACE 3 must be on bootloader binary U (30) or lower.

    This build uses bootloader binary U (30). It can be flashed on a Samsung GALAXY ACE 3 running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 4 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung GALAXY ACE 3

    No changelog details available.
    Model firmware by region