Samsung Galaxy Beam I8530VSLG1
GT-I8530 1 country Android 2.3.6 (Gingerbread)

Samsung Galaxy Beam I8530VSLG1 Firmware

Samsung Galaxy Beam I8530VSLG1 is an Android 2.3.6 (Gingerbread) firmware for Peru (SAM). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build I8530UBLG2: bootloader binary raised from U (30) to V (31), so after installing it there is no way back to older builds. A newer build for GT-I8530 is available: I8530XXLL1.

Download firmware
9.4/10 (474)8,638 times
Android 2.3.6 (Gingerbread)
OS Version
2012-07-18
Build Date
n/a
Security patch
1
Countries
1
CSC codes
V (31)
Bootloader binary

Bootloader binary V (31). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy Beam use bootloader binary X (33) (latest: I8530XXLL1). If your device already runs binary X (33), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: I8530VSLG1
    ModelRegionCSC VersionBuild DateSizeFile nameDownload
    GT-I8530
    SAM Peru
    		I8530VSLG1 2012-07-18 — —
    GT-I8530
    SAM Peru
    		I8530TFGLG1 — — —

    No matching downloads

    How to flash I8530VSLG1

    • I8530VSLG1 has bootloader binary V (31). Your device must run binary V (31) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    I8530VSLG1 is Android 2.3.6 (Gingerbread) firmware for Samsung Galaxy Beam, released for Peru (SAM). Samsung built it on 2012-07-18.

    No. A newer build for GT-I8530 is available: I8530XXLL1. Install it instead of I8530VSLG1 unless you need this exact version. The previous build was I8530UBLG2.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Beam must be on bootloader binary V (31) or lower.

    This build uses bootloader binary V (31). It can be flashed on a Samsung Galaxy Beam running binary V (31) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary V (31).

    Other builds and changelog for Samsung Galaxy Beam

    No changelog details available.
    Model firmware by region