Samsung Galaxy FEEL I8580UBUANB1 Firmware
Samsung Galaxy FEEL I8580UBUANB1 is an Android 4.2.2 firmware for Colombia (COO), Guatemala (PGU). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build I8580XXUANB1: Android updated from Jelly(Android Bean) to Android 4.2.2. A newer build for GT-I8580 is available: I8580ZNUAOG1.
8.8/10 (135)1,708 times
Android 4.2.2
OS Version
2014-03-03
Build Date
n/a
Security patch
2
Countries
2
CSC codes
U (30)
Bootloader binary
Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
Your CSC is in Settings → About phone (About tablet) → Software information, or dial *#1234#. The CSC sets your region's features and network bands. Download the firmware for your country.
MODEM/CP Version: I8580UBUANB1
No matching downloads
Device specifications
- Launched withAndroid 4.2
- Display diagonal11.9 cm (4.7")
- Display resolution480 x 800 pixels
- Display typeTFT
- Processor frequency1.2 GHz
- RAM1 GB
- Rear camera resolution5 MP
- Rear camera typeSingle camera
- SIM cardsDual SIM
- Battery capacity2000 mAh
- Weight145 g
How to flash I8580UBUANB1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- I8580UBUANB1 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
I8580UBUANB1 is Android 4.2.2 firmware for Samsung Galaxy FEEL, released for Colombia (COO), Guatemala (PGU). Samsung built it on 2014-03-03.
No. A newer build for GT-I8580 is available: I8580ZNUAOG1. Install it instead of I8580UBUANB1 unless you need this exact version. The previous build was I8580XXUANB1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy FEEL must be on bootloader binary U (30) or lower.
This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy FEEL running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 8 other builds of this model use the same binary, so you can switch between them in both directions.