Samsung Galaxy S SL I9003JPKPH Firmware
Samsung Galaxy S SL I9003JPKPH is an Android 2.3.6 (Gingerbread) firmware for Iraq (MID), Pakistan (PAK). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build I9003DXKP9: Android updated from Android 2.3.5 (Gingerbread) to Android 2.3.6 (Gingerbread); bootloader binary raised from D (13) to J (19), so after installing it there is no way back to older builds. A newer build for GT-I9003 is available: I9003XWLF3.
9.0/10 (470)8,718 times
Android 2.3.6 (Gingerbread)
OS Version
2012-02-21
Build Date
n/a
Security patch
2
Countries
2
CSC codes
J (19)
Bootloader binary
Bootloader binary J (19). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy S SL use bootloader binary X (33) (latest: I9003XWLF3). If your device already runs binary X (33), this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
Your CSC is in Settings → About phone (About tablet) → Software information, or dial *#1234#. The CSC sets your region's features and network bands. Download the firmware for your country.
MODEM/CP Version: I9003JXKP3
How to flash I9003JPKPH
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- I9003JPKPH has bootloader binary J (19). Your device must run binary J (19) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
I9003JPKPH is Android 2.3.6 (Gingerbread) firmware for Samsung Galaxy S SL, released for Iraq (MID), Pakistan (PAK). Samsung built it on 2012-02-21.
No. A newer build for GT-I9003 is available: I9003XWLF3. Install it instead of I9003JPKPH unless you need this exact version. The previous build was I9003DXKP9.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S SL must be on bootloader binary J (19) or lower.
This build uses bootloader binary J (19). It can be flashed on a Samsung Galaxy S SL running binary J (19) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 2 other builds of this model use the same binary, so you can switch between them in both directions.