GT-I9003 1 country Android 2.3.6 (Gingerbread)

Samsung Galaxy S SL I9003POLJ1 Firmware

Name: Samsung Galaxy S SL (GT-I9003)
Brand: Samsung
Availability: InStock

Samsung Galaxy S SL I9003POLJ1 is an Android 2.3.6 (Gingerbread) firmware for France (BOG). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build I9003JVKPE https://samfirm.shop/build/I9003JVKPE: bootloader binary raised from J (19) to P (25), so after installing it there is no way back to older builds. A newer build for GT-I9003 is available: I9003XWLF3 https://samfirm.shop/build/I9003XWLF3.

9.2/10 (472)4,369 times

Android 2.3.6 (Gingerbread)

OS Version

2012-10-08

Build Date

n/a

Security patch

Countries

CSC codes

P (25)

Bootloader binary

Bootloader binary P (25). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy S SL use bootloader binary X (33) (latest: I9003XWLF3). If your device already runs binary X (33), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: I9003BOGLJ3

Model	Region	CSC Version	Size	File name	Download
GT-I9003	BOG France	I9003XXLE4	—	—

How to flash I9003POLJ1

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

I9003POLJ1 has bootloader binary P (25). Your device must run binary P (25) or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

I9003POLJ1 is Android 2.3.6 (Gingerbread) firmware for Samsung Galaxy S SL, released for France (BOG). Samsung built it on 2012-10-08.

No. A newer build for GT-I9003 is available: I9003XWLF3. Install it instead of I9003POLJ1 unless you need this exact version. The previous build was I9003JVKPE.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S SL must be on bootloader binary P (25) or lower.

This build uses bootloader binary P (25). It can be flashed on a Samsung Galaxy S SL running binary P (25) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary P (25).