Samsung GALAXY S I9008LZMLD1
GT-I9008L 1 country Android 2.2.3 (Froyo)

Samsung GALAXY S I9008LZMLD1 Firmware

Samsung GALAXY S I9008LZMLD1 is an Android 2.2.3 (Froyo) firmware for China (CHN). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. This is the newest build for GT-I9008L.

Download firmware
9.1/10 (475)4,212 times
Android 2.2.3 (Froyo)
OS Version
2012-04-03
Build Date
1
Countries
1
CSC codes
Z (35)
Bootloader binary

Bootloader binary Z (35). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: I9008LCHNLD1
    ModelRegionCSC VersionSizeFile nameDownload
    GT-I9008L
    CHN China
    		I9008LZMLD1 — —

    No matching downloads

    How to flash I9008LZMLD1

    • I9008LZMLD1 has bootloader binary Z (35). Your device must run binary Z (35) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    I9008LZMLD1 is Android 2.2.3 (Froyo) firmware for Samsung GALAXY S, released for China (CHN). Samsung built it on 2012-04-03.

    Yes. I9008LZMLD1 is the newest build for GT-I9008L on SamFirm.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung GALAXY S must be on bootloader binary Z (35) or lower.

    This build uses bootloader binary Z (35). It can be flashed on a Samsung GALAXY S running binary Z (35) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary Z (35).

    Other builds and changelog for Samsung GALAXY S

    No changelog details available.
    Model firmware by region