GT-I9105 6 countries Android 4.1.2 (Jelly Bean)

Samsung Galaxy S Ⅱ Plus I9105XXAMB1 Firmware

Name: Samsung Galaxy S Ⅱ Plus (GT-I9105)
Brand: Samsung
Availability: InStock

Samsung Galaxy S Ⅱ Plus I9105XXAMB1 is an Android 4.1.2 (Jelly Bean) firmware for 6 countries, 6 CSC codes. It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build I9105XXUBND1: Android updated from Jelly(Android Bean) to Android 4.1.2 (Jelly Bean); bootloader binary raised from U (30) to X (33), so after installing it there is no way back to older builds. A newer build for GT-I9105 is available: I9105XXANL2.

9.2/10 (470)25,479 times

Android 4.1.2 (Jelly Bean)

OS Version

2013-02-01

Build Date

n/a

Security patch

Countries

CSC codes

X (33)

Bootloader binary

Bootloader binary X (33). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

Not sure which one to download?

Your CSC is in Settings → About phone (About tablet) → Software information, or dial *#1234#. The CSC sets your region's features and network bands. Download the firmware for your country.

MODEM/CP Version: I9105XXAMB1

Model	Region	CSC Version	Release date	Size	File name
GT-I9105	AFR Kenya	I9105OJVAMA1	2013-02-22	—	—
GT-I9105	CAC Uzbekistan	I9105OXEAMB1	2013-02-18	1.07 GiB	GT-I9105_1_20151029153153_2nd3rru15f_fac.zip
GT-I9105	EGY Egypt	I9105OJVAMA1	—	—	—
GT-I9105	KSA Saudi Arabia	I9105OJVAMA1	2013-02-18	776.033 MiB	GT-I9105_1_20150923162701_0ajgusp55v_fac.zip
GT-I9105	MRT Mauritania	I9105OJVAMA1	2013-03-19	—	—
GT-I9105	SER Russia	I9105OXEAMB1	2013-02-13	1.07 GiB	GT-I9105_SER_1_20150115160530_acoksn54cm_fac.zip

Device specifications

Launched withAndroid 4.1
Display diagonal10.9 cm (4.3")
Display resolution800 x 480 pixels
Display typeAMOLED
Processor frequency1.2 GHz
RAM1 GB
Rear camera resolution8 MP
Rear camera typeSingle camera
SIM cardsSingle SIM
Battery capacity1650 mAh
Weight121 g

How to flash I9105XXAMB1

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

I9105XXAMB1 has bootloader binary X (33). Your device must run binary X (33) or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

I9105XXAMB1 is Android 4.1.2 (Jelly Bean) firmware for Samsung Galaxy S Ⅱ Plus, released for 6 countries, 6 CSC codes. Samsung built it on 2013-02-01.

No. A newer build for GT-I9105 is available: I9105XXANL2. Install it instead of I9105XXAMB1 unless you need this exact version. The previous build was I9105XXUBND1.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S Ⅱ Plus must be on bootloader binary X (33) or lower.

This build uses bootloader binary X (33). It can be flashed on a Samsung Galaxy S Ⅱ Plus running binary X (33) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 3 other builds of this model use the same binary, so you can switch between them in both directions.