GT-I9305 18 countries
Samsung Galaxy S 3 LTE I9305XXUEMKC Firmware
Samsung Galaxy S 3 LTE I9305XXUEMKC is an Android firmware for 18 countries, 22 CSC codes. It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build I9305ZHUCNB1, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for GT-I9305 is available: I9305XXBMR8.
9.0/10 (470)95,243 times
n/a
OS Version
2013-11-28
First release
other regions until 2014-01-02
n/a
Security patch
18
Countries
22
CSC codes
U (30)
Bootloader binary
Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy S 3 LTE use bootloader binary X (33) (latest: I9305XXBMR8). If your device already runs binary X (33), this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
Your CSC is in Settings → About phone (About tablet) → Software information, or dial *#1234#. The CSC sets your region's features and network bands. Download the firmware for your country.
22
MODEM/CP Version: I9305XXUEMK1
No matching downloads
Device specifications
- Launched withAndroid 4.1.1
- Display diagonal12.2 cm (4.8")
- Display resolution1280 x 720 pixels
- Display typeAMOLED
- Processor frequency1.4 GHz
- RAM2 GB
- Rear camera resolution8 MP
- Rear camera typeSingle camera
- Battery capacity2100 mAh
- Weight131 g
How to flash I9305XXUEMKC
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- I9305XXUEMKC has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
No. A newer build for GT-I9305 is available: I9305XXBMR8. Install it instead of I9305XXUEMKC unless you need this exact version. The previous build was I9305ZHUCNB1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S 3 LTE must be on bootloader binary U (30) or lower.
This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy S 3 LTE running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 25 other builds of this model use the same binary, so you can switch between them in both directions.