Samsung Galaxy S 3 LTE I9305XXUENC1
GT-I9305 3 countries

Samsung Galaxy S 3 LTE I9305XXUENC1 Firmware

Samsung Galaxy S 3 LTE I9305XXUENC1 is an Android firmware for France (SFR), Netherlands (VDF), Poland (TPL). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build I9305XXUENA2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for GT-I9305 is available: I9305XXBMR8.

9.1/10 (472)13,095 times
n/a
OS Version
2014-03-18
Build Date
n/a
Security patch
3
Countries
3
CSC codes
U (30)
Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy S 3 LTE use bootloader binary X (33) (latest: I9305XXBMR8). If your device already runs binary X (33), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    Your CSC is in Settings → About phone (About tablet) → Software information, or dial *#1234#. The CSC sets your region's features and network bands. Download the firmware for your country.
    ModelRegionCSC VersionMODEM/CP VersionRelease dateSizeFile nameDownload
    GT-I9305
    SFR France
    		I9305SFRENC1I9305AEUENC1 2014-04-18 987.944 MiB
    GT-I9305_1_20170519203339_78h3646u3u_fac.zip
    GT-I9305
    TPL Poland
    		I9305TPLENE1I9305XXUENE2 2014-05-22 1.033 GiB
    GT-I9305_1_20170502204439_l6dt97qra3_fac.zip
    GT-I9305
    VDF Netherlands
    		I9305VDFEND1I9305XXUEND1 2014-05-20 985.112 MiB
    GT-I9305_1_20170502210800_2cq4b18lpe_fac.zip

    No matching downloads

    Device specifications

    • Launched withAndroid 4.1.1
    • Display diagonal12.2 cm (4.8")
    • Display resolution1280 x 720 pixels
    • Display typeAMOLED
    • Processor frequency1.4 GHz
    • RAM2 GB
    • Rear camera resolution8 MP
    • Rear camera typeSingle camera
    • Battery capacity2100 mAh
    • Weight131 g

    Rollout of I9305XXUENC1 by region

    First release on April 18, 2014: SFR (France). Regions in total: 3, the rollout took 34 days, the last region got the build on May 22, 2014.

    • 2014-04-18 SFR (France)
    • 2014-05-20 VDF (Netherlands)
    • 2014-05-22 TPL (Poland)

    How to flash I9305XXUENC1

    • I9305XXUENC1 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for GT-I9305 is available: I9305XXBMR8. Install it instead of I9305XXUENC1 unless you need this exact version. The previous build was I9305XXUENA2.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S 3 LTE must be on bootloader binary U (30) or lower.

    This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy S 3 LTE running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 25 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy S 3 LTE

    No changelog details available.
    Model firmware by region