SM-J337AZ 1 country Android 8.0.0

Samsung Galaxy J3 Top J337AZTUS9ATB2 Firmware

Samsung Galaxy J3 Top J337AZTUS9ATB2 is an Android 8.0.0 firmware for United States (AIO). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build J337AZTUS8ASK1: bootloader binary raised from 8 to 9, so after installing it there is no way back to older builds. A newer build for SM-J337AZ is available: J337AZTUSDAVK1.

Download firmware
9.2/10 (456)4,423 times
Android 8.0.0
OS Version
2020-02-17
Build Date
1
Countries
1
CSC codes
9
Bootloader binary

Bootloader binary 9. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy J3 Top use bootloader binary D (13) (latest: J337AZTUSDAVK1). If your device already runs binary D (13), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: J337AZTUS9ATB2
    ModelRegionCSC VersionSizeFile nameDownload
    SM-J337AZ
    AIO United States
    		J337AZ9ATB2 — —

    No matching downloads

    How to flash J337AZTUS9ATB2

    • J337AZTUS9ATB2 has bootloader binary 9. Your device must run binary 9 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    J337AZTUS9ATB2 is Android 8.0.0 firmware for Samsung Galaxy J3 Top, released for United States (AIO). Samsung built it on 2020-02-17.

    No. A newer build for SM-J337AZ is available: J337AZTUSDAVK1. Install it instead of J337AZTUS9ATB2 unless you need this exact version. The previous build was J337AZTUS8ASK1.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy J3 Top must be on bootloader binary 9 or lower.

    This build uses bootloader binary 9. It can be flashed on a Samsung Galaxy J3 Top running binary 9 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary 9.

    Other builds and changelog for Samsung Galaxy J3 Top

    No changelog details available.
    Model firmware by region