Samsung Galaxy J4 Core J410GUBS1ASC4
SM-J410G 1 country Android 8.1.0 (Oreo)

Samsung Galaxy J4 Core J410GUBS1ASC4 Firmware

Samsung Galaxy J4 Core J410GUBS1ASC4 is an Android 8.1.0 (Oreo) firmware for Dominican Republic (CDR). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build J410GUBS1ASC3, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-J410G is available: J410GUBU1AZB2.

8.7/10 (452)4,385 times
Android 8.1.0 (Oreo)
OS Version
2019-03-18
Build Date
2019-03-01
Security patch
1
Countries
1
CSC codes
1
Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: J410GUBS1ASC4
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    SM-J410G
    CDR Dominican Republic
    		J410G1ASA1 2019-04-06 — —

    No matching downloads

    Device specifications

    • Launched withAndroid 8.1
    • Display diagonal15.2 cm (6")
    • Display resolution1480 x 720 pixels
    • Display typeTFT
    • RAM1 GB
    • Rear camera resolution8 MP
    • Rear camera typeSingle camera
    • Battery capacity3300 mAh
    • Weight177 g

    Specifications of SM-J410F, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.

    What's new in J410GUBS1ASC4

    · The security of your device has been improved.

    How to flash J410GUBS1ASC4

    • J410GUBS1ASC4 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    J410GUBS1ASC4 is Android 8.1.0 (Oreo) firmware for Samsung Galaxy J4 Core, released for Dominican Republic (CDR). It includes the 2019-03-01 security patch. Samsung built it on 2019-03-18.

    No. A newer build for SM-J410G is available: J410GUBU1AZB2. Install it instead of J410GUBS1ASC4 unless you need this exact version. The previous build was J410GUBS1ASC3.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy J4 Core must be on bootloader binary 1 or lower.

    This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy J4 Core running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 96 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy J4 Core

    • Stability and reliability
    Device behavior has been improved.

    These changes may vary depending on the model, country, or network operator of the customer environment.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    Show 15 older builds

    • The security of your device has been improved.

    • The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    · The security of your device has been improved.

    Model firmware by region