SM-M446K 1 country Android 16

Samsung Galaxy Jump3 M446KKSS7EYL1 Firmware

Samsung Galaxy Jump3 M446KKSS7EYL1 is an Android 16 firmware for South Korea (KTC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build M446KKSU6EYJ3: bootloader binary raised from 6 to 7, so after installing it there is no way back to older builds. A newer build for SM-M446K is available: M446KKSSAEZH1.

Download firmware
9.4/10 (176)1,002 times
Android 16
OS Version
2025-12-17
Build Date
1
Countries
1
CSC codes
7
Bootloader binary

Bootloader binary 7. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy Jump3 use bootloader binary A (10) (latest: M446KKSSAEZH1). If your device already runs binary A (10), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: M446KKSS7EYL1
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    SM-M446K
    KTC South Korea
    		M446KKTC7EYL1 2025-12-17 7.91 GiB
    SM-M446K_3_20251208101051_wsaia5xlzl_fac.zip

    No matching downloads

    How to flash M446KKSS7EYL1

    • M446KKSS7EYL1 has bootloader binary 7. Your device must run binary 7 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    M446KKSS7EYL1 is Android 16 firmware for Samsung Galaxy Jump3, released for South Korea (KTC). Samsung built it on 2025-12-17.

    No. A newer build for SM-M446K is available: M446KKSSAEZH1. Install it instead of M446KKSS7EYL1 unless you need this exact version. The previous build was M446KKSU6EYJ3.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 7.91 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Jump3 must be on bootloader binary 7 or lower.

    This build uses bootloader binary 7. It can be flashed on a Samsung Galaxy Jump3 running binary 7 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary 7.

    Other builds and changelog for Samsung Galaxy Jump3

    No changelog details available.
    Model firmware by region