Samsung Galaxy Note N7000BDVLSA
GT-N7000B 1 country

Samsung Galaxy Note N7000BDVLSA Firmware

Samsung Galaxy Note N7000BDVLSA is an Android firmware for Australia (VAU). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N7000BDULSA, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for GT-N7000B is available: N7000BDVLSB.

8.9/10 (451)4,455 times
n/a
OS Version
n/a
Build Date
n/a
Security patch
1
Countries
1
CSC codes
D (13)
Bootloader binary

Bootloader binary D (13). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: N7000BDULS7
    ModelRegionCSC VersionSizeFile nameDownload
    GT-N7000B
    VAU Australia
    		N7000BVAULSA — —

    No matching downloads

    How to flash N7000BDVLSA

    • N7000BDVLSA has bootloader binary D (13). Your device must run binary D (13) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for GT-N7000B is available: N7000BDVLSB. Install it instead of N7000BDVLSA unless you need this exact version. The previous build was N7000BDULSA.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Note must be on bootloader binary D (13) or lower.

    This build uses bootloader binary D (13). It can be flashed on a Samsung Galaxy Note running binary D (13) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 3 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Note

    No changelog details available.
    No changelog details available.
    No changelog details available.
    No changelog details available.
    Model firmware by region