Samsung Galaxy Note N7000BDVLSB
GT-N7000B 1 country

Samsung Galaxy Note N7000BDVLSB Firmware

Samsung Galaxy Note N7000BDVLSB is an Android firmware for Australia (TEL). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N7000BDVLSA, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. This is the newest build for GT-N7000B.

9.1/10 (470)4,406 times
n/a
OS Version
2013-05-07
Build Date
n/a
Security patch
1
Countries
1
CSC codes
D (13)
Bootloader binary

Bootloader binary D (13). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: N7000BDVLS7
    ModelRegionCSC VersionSizeFile nameDownload
    GT-N7000B
    TEL Australia
    		N7000BTELLSB — —

    No matching downloads

    How to flash N7000BDVLSB

    • N7000BDVLSB has bootloader binary D (13). Your device must run binary D (13) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    Yes. N7000BDVLSB is the newest build for GT-N7000B on SamFirm. The previous build was N7000BDVLSA.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Note must be on bootloader binary D (13) or lower.

    This build uses bootloader binary D (13). It can be flashed on a Samsung Galaxy Note running binary D (13) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 3 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Note

    No changelog details available.
    No changelog details available.
    No changelog details available.
    No changelog details available.
    Model firmware by region