Samsung Galaxy Note3 Neo N7505POSDRI1
SM-N7505 1 country Android 5.1.1 (Lollipop)

Samsung Galaxy Note3 Neo N7505POSDRI1 Firmware

Samsung Galaxy Note3 Neo N7505POSDRI1 is an Android 5.1.1 (Lollipop) firmware for France (BOG). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N7505POSDPL2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-N7505 is available: N7505POUDPF1.

Download firmware
9.3/10 (475)8,677 times
Android 5.1.1 (Lollipop)
OS Version
2018-09-27
First release
other regions until 2018-12-07
1
Countries
1
CSC codes
S (28)
Bootloader binary

Bootloader binary S (28). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy Note3 Neo use bootloader binary U (30) (latest: N7505POUDPF1). If your device already runs binary U (30), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    ModelRegionCSC VersionMODEM/CP VersionBuild DateRelease dateSizeFile nameDownload
    SM-N7505
    BOG France
    		N7505BOGDRI1N7505XXUDOK4 2018-12-07 2018-12-10 1.196 GiB
    SM-N7505_1_20181207105814_5yeroc6eyf_fac.zip
    SM-N7505
    BOG France
    		N7505DRI1N7505POSDRI1 2018-09-27 — — —

    No matching downloads

    How to flash N7505POSDRI1

    • N7505POSDRI1 has bootloader binary S (28). Your device must run binary S (28) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Device specifications

    • Display diagonal14 cm (5.5")
    • Display resolution1280 x 720 pixels
    • Display typeSAMOLED
    • Processor frequency1.7 GHz
    • RAM2 GB
    • Rear camera resolution8 MP
    • Rear camera typeSingle camera
    • SIM cardsSingle SIM
    • Battery capacity3100 mAh
    • Weight162.5 g

    Frequently Asked Questions

    N7505POSDRI1 is Android 5.1.1 (Lollipop) firmware for Samsung Galaxy Note3 Neo, released for France (BOG). Samsung built it on 2018-09-27.

    No. A newer build for SM-N7505 is available: N7505POUDPF1. Install it instead of N7505POSDRI1 unless you need this exact version. The previous build was N7505POSDPL2.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 1.196 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Note3 Neo must be on bootloader binary S (28) or lower.

    This build uses bootloader binary S (28). It can be flashed on a Samsung Galaxy Note3 Neo running binary S (28) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 8 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Note3 Neo

    No changelog details available.
    Model firmware by region