Samsung Galaxy Note3 Neo N7505ZHUAND1

Samsung Galaxy Note3 Neo N7505ZHUAND1 Firmware

Samsung Galaxy Note3 Neo N7505ZHUAND1 is an Android firmware for Hong Kong SAR China (TGY). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N7505XXUANB5 https://samfirm.shop/build/N7505XXUANB5, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-N7505 is available: N7505POUDPF1 https://samfirm.shop/build/N7505POUDPF1.

Download firmware
9.2/10 (479)4,381 times
2014-04-01
Build Date
1
Countries
1
CSC codes
U (30)
Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: N7505ZHUAND1
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    SM-N7505
    TGY Hong Kong SAR China
    N7505ZZHAND1 2014-04-25 1.303 GiB
    SM-N7505_1_20151125185040_mhlpi9sjjh_fac.zip
    Download

    No matching downloads

    How to flash N7505ZHUAND1

    • N7505ZHUAND1 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Device specifications

    • Display diagonal14 cm (5.5")
    • Display resolution1280 x 720 pixels
    • Display typeSAMOLED
    • Processor frequency1.7 GHz
    • RAM2 GB
    • Rear camera resolution8 MP
    • Rear camera typeSingle camera
    • SIM cardsSingle SIM
    • Battery capacity3100 mAh
    • Weight162.5 g

    Frequently Asked Questions

    No. A newer build for SM-N7505 is available: N7505POUDPF1. Install it instead of N7505ZHUAND1 unless you need this exact version. The previous build was N7505XXUANB5.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 1.303 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Note3 Neo must be on bootloader binary U (30) or lower.

    This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Note3 Neo running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 26 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Note3 Neo

    https://samfirm.shop/build/N7505POUDPF1
    No changelog details available.