Samsung Galaxy Note3 N900PVPUBMI5
SM-N900P 1 country

Samsung Galaxy Note3 N900PVPUBMI5 Firmware

Samsung Galaxy Note3 N900PVPUBMI5 is an Android firmware for United States (SPR). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N900PVPSEPL1: bootloader binary raised from S (28) to U (30), so after installing it there is no way back to older builds. A newer build for SM-N900P is available: N900PVPUEPH1.

Download firmware
9.3/10 (478)4,307 times
2013-09-16
Build Date
1
Countries
1
CSC codes
U (30)
Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: N900PVPUBMI5
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    SM-N900P
    SPR United States
    		N900PSPTBMI5 2013-10-24 1.426 GiB
    SM-N900P_1_20170208200100_d44e06anh8_fac.zip
    		Download

    No matching downloads

    How to flash N900PVPUBMI5

    • N900PVPUBMI5 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Device specifications

    • Display diagonal14.5 cm (5.7")
    • Display resolution1920 x 1080 pixels
    • Rear camera resolution13 MP
    • Rear camera typeSingle camera
    • Battery capacity3200 mAh
    • Weight168 g

    Specifications of SM-N900, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.

    Frequently Asked Questions

    No. A newer build for SM-N900P is available: N900PVPUEPH1. Install it instead of N900PVPUBMI5 unless you need this exact version. The previous build was N900PVPSEPL1.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 1.426 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Note3 must be on bootloader binary U (30) or lower.

    This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Note3 running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 7 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Note3

    No changelog details available.
    Model firmware by region