Samsung Galaxy Note5 N9208ZTS3BPI2
SM-N9208 1 country Android 6.0.1 (Marshmallow)

Samsung Galaxy Note5 N9208ZTS3BPI2 Firmware

Samsung Galaxy Note5 N9208ZTS3BPI2 is an Android 6.0.1 (Marshmallow) firmware for Taiwan (BRI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N9208XXU2BPH4: Android updated from Android 6.0.1 (Nougat) to Android 6.0.1 (Marshmallow); bootloader binary raised from 2 to 3, so after installing it there is no way back to older builds. A newer build for SM-N9208 is available: N9208ZTU6CVG1.

9.2/10 (454)4,207 times
Android 6.0.1 (Marshmallow)
OS Version
2016-09-12
Build Date
n/a
Security patch
1
Countries
1
CSC codes
3
Bootloader binary

Bootloader binary 3. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy Note5 use bootloader binary 6 (latest: N9208ZTU6CVG1). If your device already runs binary 6, this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: N9208ZTS3BPI2
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    SM-N9208
    BRI Taiwan
    		N9208ZZT3BPI2 2016-09-29 — —

    No matching downloads

    Device specifications

    • Launched withAndroid 5.1.1
    • Display diagonal14.5 cm (5.7")
    • Display resolution2560 x 1440 pixels
    • Display typeSAMOLED
    • RAM4 GB
    • Rear camera resolution16 MP
    • Rear camera typeSingle camera
    • Battery capacity3000 mAh
    • Weight170.9476 g

    Specifications of SM-N920, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.

    What's new in N9208ZTS3BPI2

    - The latest Android security patch has been applied.
    ㆍDevice security has been further enhanced.

    How to flash N9208ZTS3BPI2

    • N9208ZTS3BPI2 has bootloader binary 3. Your device must run binary 3 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    N9208ZTS3BPI2 is Android 6.0.1 (Marshmallow) firmware for Samsung Galaxy Note5, released for Taiwan (BRI). Samsung built it on 2016-09-12.

    No. A newer build for SM-N9208 is available: N9208ZTU6CVG1. Install it instead of N9208ZTS3BPI2 unless you need this exact version. The previous build was N9208XXU2BPH4.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Note5 must be on bootloader binary 3 or lower.

    This build uses bootloader binary 3. It can be flashed on a Samsung Galaxy Note5 running binary 3 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 40 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Note5

    • GPS
    The stability has been improved.
    • The latest Android security patch has been applied.
    - Device security has been further enhanced.

    • GPS
    The stability has been improved.
    • Security
    The device is protected with improved security.

    • GPS
    The stability has been improved.
    • Security
    The device is protected with improved security.

    - The latest Android security patch has been applied.
    ㆍDevice security has been further enhanced.

    No changelog details available.
    Show 15 older builds
    No changelog details available.
    No changelog details available.
    No changelog details available.

    - Other bug fixes
    ㆍThe Stability of Wifi and Bluetooth has been improved.
    ㆍThe stability of gallery app has been improved.
    - The latest Android security patch has been applied.
    ㆍDevice security has been further enhanced.

    - The latest Android security patch has been applied.
    ㆍDevice security has been further enhanced.

    No changelog details available.
    No changelog details available.
    No changelog details available.

    - The latest Android security patch has been applied.
    ㆍDevice security has been further enhanced.

    No changelog details available.
    No changelog details available.

    - The latest Android security patch has been applied.
    ㆍDevice security has been further enhanced.

    No changelog details available.

    - Improved performance
    ㆍWPA 2 Wi-Fi security is enhanced.
    - Other bug fixes
    ㆍFixed issue  that the photo disappears in the gallery application.
    ㆍFixed issue that the of anomaly of low battery message from Power saving mode.
    - The latest Android security patch has been applied.
    ㆍDevice security has been further enhanced.

    No changelog details available.
    Model firmware by region