Samsung Galaxy Note5 N920KKKU1AOGI Firmware
Samsung Galaxy Note5 N920KKKU1AOGI is an Android 5.1.1 (Marshmallow) firmware for South Korea (KTC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SM-N920K is available: N920KKKU2DVG1.
8.9/10 (451)4,365 times
Android 5.1.1 (Marshmallow)
OS Version
2015-07-24
Build Date
n/a
Security patch
1
Countries
1
CSC codes
1
Bootloader binary
Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy Note5 use bootloader binary 2 (latest: N920KKKU2DVG1). If your device already runs binary 2, this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: N920KKKU1AOGI
Device specifications
- Launched withAndroid 5.1.1
- Display diagonal14.5 cm (5.7")
- Display resolution2560 x 1440 pixels
- Display typeSAMOLED
- RAM4 GB
- Rear camera resolution16 MP
- Rear camera typeSingle camera
- Battery capacity3000 mAh
- Weight170.9476 g
Specifications of SM-N920, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.
How to flash N920KKKU1AOGI
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- N920KKKU1AOGI has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
N920KKKU1AOGI is Android 5.1.1 (Marshmallow) firmware for Samsung Galaxy Note5, released for South Korea (KTC). Samsung built it on 2015-07-24.
No. A newer build for SM-N920K is available: N920KKKU2DVG1. Install it instead of N920KKKU1AOGI unless you need this exact version.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Note5 must be on bootloader binary 1 or lower.
This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy Note5 running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 2 other builds of this model use the same binary, so you can switch between them in both directions.