Samsung Galaxy Note5 N920KKKU2DQL1
SM-N920K 1 country Android 7.0 (Marshmallow)

Samsung Galaxy Note5 N920KKKU2DQL1 Firmware

Samsung Galaxy Note5 N920KKKU2DQL1 is an Android 7.0 (Marshmallow) firmware for South Korea (KTC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build N920KKKU2DQK2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-N920K is available: N920KKKU2DVG1.

Download firmware
9.0/10 (460)8,669 times
Android 7.0 (Marshmallow)
OS Version
2017-12-06
Build Date
1
Countries
1
CSC codes
2
Bootloader binary

Bootloader binary 2. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    ModelRegionCSC VersionMODEM/CP VersionRelease dateSizeFile nameDownload
    SM-N920K
    KTC South Korea
    		N920K2DQL1N920KKKU2DQL1 — — — Download
    SM-N920K
    KTC South Korea
    		N920KKTC2DQL1N920KKKU2DQK1 2017-12-21 2.382 GiB
    SM-N920K_1_20220818183930_mg6okai8p1_fac.zip
    		Download

    No matching downloads

    How to flash N920KKKU2DQL1

    • N920KKKU2DQL1 has bootloader binary 2. Your device must run binary 2 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Device specifications

    • Launched withAndroid 5.1.1
    • Display diagonal14.5 cm (5.7")
    • Display resolution2560 x 1440 pixels
    • Display typeSAMOLED
    • RAM4 GB
    • Rear camera resolution16 MP
    • Rear camera typeSingle camera
    • Battery capacity3000 mAh
    • Weight170.9476 g

    Specifications of SM-N920, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.

    Frequently Asked Questions

    N920KKKU2DQL1 is Android 7.0 (Marshmallow) firmware for Samsung Galaxy Note5, released for South Korea (KTC). Samsung built it on 2017-12-06.

    No. A newer build for SM-N920K is available: N920KKKU2DVG1. Install it instead of N920KKKU2DQL1 unless you need this exact version. The previous build was N920KKKU2DQK2.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 2.382 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Note5 must be on bootloader binary 2 or lower.

    This build uses bootloader binary 2. It can be flashed on a Samsung Galaxy Note5 running binary 2 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 21 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Note5

    No changelog details available.
    Model firmware by region