Samsung GALAXY Tab 7.0 P1010ZTLE7
GT-P1010 1 country Android 2.3.6 (Gingerbread)

Samsung GALAXY Tab 7.0 P1010ZTLE7 Firmware

Samsung GALAXY Tab 7.0 P1010ZTLE7 is an Android 2.3.6 (Gingerbread) firmware for Taiwan (BRI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P1010ZCLI2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. This is the newest build for GT-P1010.

9.4/10 (471)4,403 times
Android 2.3.6 (Gingerbread)
OS Version
2012-07-12
Build Date
n/a
Security patch
1
Countries
1
CSC codes
Z (35)
Bootloader binary

Bootloader binary Z (35). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: P1010ZTLE7
    ModelRegionCSC VersionSizeFile nameDownload
    GT-P1010
    BRI Taiwan
    		P1010BRILE7 — —

    No matching downloads

    How to flash P1010ZTLE7

    • P1010ZTLE7 has bootloader binary Z (35). Your device must run binary Z (35) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    P1010ZTLE7 is Android 2.3.6 (Gingerbread) firmware for Samsung GALAXY Tab 7.0, released for Taiwan (BRI). Samsung built it on 2012-07-12.

    Yes. P1010ZTLE7 is the newest build for GT-P1010 on SamFirm. The previous build was P1010ZCLI2.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung GALAXY Tab 7.0 must be on bootloader binary Z (35) or lower.

    This build uses bootloader binary Z (35). It can be flashed on a Samsung GALAXY Tab 7.0 running binary Z (35) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung GALAXY Tab 7.0

    No changelog details available.
    No changelog details available.
    No changelog details available.
    No changelog details available.
    Model firmware by region