Samsung GT-P5110 P5110XWALE1
GT-P5110 1 country

Samsung GT-P5110 P5110XWALE1 Firmware

Samsung GT-P5110 P5110XWALE1 is an Android firmware for Bulgaria (BGL). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P5110JKDMG1: bootloader binary raised from K (20) to W (32), so after installing it there is no way back to older builds. A newer build for GT-P5110 is available: P5110XXDNH2.

Download firmware
9.0/10 (478)4,387 times
2012-05-02
Build Date
1
Countries
1
CSC codes
W (32)
Bootloader binary

Bootloader binary W (32). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung GT-P5110 use bootloader binary X (33) (latest: P5110XXDNH2). If your device already runs binary X (33), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: P5110XWALE1
    ModelRegionCSC VersionSizeFile nameDownload
    GT-P5110
    BGL Bulgaria
    		P5110OXXALE1 968.927 MiB
    GT-P5110_BGL_1_20140720163520_vyy4f482p6_fac.zip
    		Download

    No matching downloads

    How to flash P5110XWALE1

    • P5110XWALE1 has bootloader binary W (32). Your device must run binary W (32) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for GT-P5110 is available: P5110XXDNH2. Install it instead of P5110XWALE1 unless you need this exact version. The previous build was P5110JKDMG1.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 968.927 MiB; keep about twice that free on the computer to unzip it. The Samsung GT-P5110 must be on bootloader binary W (32) or lower.

    This build uses bootloader binary W (32). It can be flashed on a Samsung GT-P5110 running binary W (32) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung GT-P5110

    No changelog details available.
    Model firmware by region