Samsung Galaxy Tab3 P5210XXUBNJ1
GT-P5210 1 country Android 4.4.2 (KitKat)

Samsung Galaxy Tab3 P5210XXUBNJ1 Firmware

Samsung Galaxy Tab3 P5210XXUBNJ1 is an Android 4.4.2 (KitKat) firmware for Spain (XEC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P5210XXUBNI1, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for GT-P5210 is available: P5210XXUBPF1.

Download firmware
8.7/10 (459)4,399 times
Android 4.4.2 (KitKat)
OS Version
1
Countries
1
CSC codes
U (30)
Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: P5210XXUBNJ1
    ModelRegionCSC VersionSizeFile nameDownload
    GT-P5210
    XEC Spain
    		P5210XECBNJ1 — — Download

    No matching downloads

    How to flash P5210XXUBNJ1

    • P5210XXUBNJ1 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    P5210XXUBNJ1 is Android 4.4.2 (KitKat) firmware for Samsung Galaxy Tab3, released for Spain (XEC).

    No. A newer build for GT-P5210 is available: P5210XXUBPF1. Install it instead of P5210XXUBNJ1 unless you need this exact version. The previous build was P5210XXUBNI1.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Tab3 must be on bootloader binary U (30) or lower.

    This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Tab3 running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 30 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Tab3

    No changelog details available.
    Model firmware by region