Samsung Galaxy Tab A 9.7 P555SKST1CTI2
SM-P555S 1 country Android 6.0.1 (Lollipop)

Samsung Galaxy Tab A 9.7 P555SKST1CTI2 Firmware

Samsung Galaxy Tab A 9.7 P555SKST1CTI2 is an Android 6.0.1 (Lollipop) firmware for South Korea (SKC). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P555SKSU1CQL3: Android updated from Android 7.1.1 (Nougat) to Android 6.0.1 (Lollipop). A newer build for SM-P555S is available: P555SKSS1CTI2.

Download firmware
9.1/10 (457)4,207 times
Android 6.0.1 (Lollipop)
OS Version
1
Countries
1
CSC codes
1
Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: P555SKSU1CQL3
    ModelRegionCSC VersionSizeFile nameDownload
    SM-P555S
    SKC South Korea
    		P555SSKC1CTI2 — — Download

    No matching downloads

    How to flash P555SKST1CTI2

    • P555SKST1CTI2 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    P555SKST1CTI2 is Android 6.0.1 (Lollipop) firmware for Samsung Galaxy Tab A 9.7, released for South Korea (SKC).

    No. A newer build for SM-P555S is available: P555SKSS1CTI2. Install it instead of P555SKST1CTI2 unless you need this exact version. The previous build was P555SKSU1CQL3.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Tab A 9.7 must be on bootloader binary 1 or lower.

    This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy Tab A 9.7 running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 5 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Tab A 9.7

    No changelog details available.
    Model firmware by region