Samsung Galaxy Note 10.1 P601UBSDSA2 Firmware
Samsung Galaxy Note 10.1 P601UBSDSA2 is an Android 4.4.2 (KitKat) firmware for Brazil (ZTO). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P601UBSDSA1: Android updated from Android 4.4.2 (Lollipop) to Android 4.4.2 (KitKat). A newer build for SM-P601 is available: P601XXUDQA1.
9.0/10 (451)8,618 times
Android 4.4.2 (KitKat)
OS Version
2019-01-25
First release
other regions until 2019-03-12
n/a
Security patch
1
Countries
1
CSC codes
S (28)
Bootloader binary
Bootloader binary S (28). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy Note 10.1 use bootloader binary U (30) (latest: P601XXUDQA1). If your device already runs binary U (30), this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
Device specifications
- Display diagonal25.6 cm (10.1")
- Display resolution2560 x 1600 pixels
- Rear camera resolution8 MP
- Rear camera typeSingle camera
- Front camera resolution2 MP
- Wi-Fi standardWi-Fi 5 (802.11ac)
- Weight547 g
Specifications of SM-P6010, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.
How to flash P601UBSDSA2
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- P601UBSDSA2 has bootloader binary S (28). Your device must run binary S (28) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
P601UBSDSA2 is Android 4.4.2 (KitKat) firmware for Samsung Galaxy Note 10.1, released for Brazil (ZTO). Samsung built it on 2019-01-25.
No. A newer build for SM-P601 is available: P601XXUDQA1. Install it instead of P601UBSDSA2 unless you need this exact version. The previous build was P601UBSDSA1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 1.353 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Note 10.1 must be on bootloader binary S (28) or lower.
This build uses bootloader binary S (28). It can be flashed on a Samsung Galaxy Note 10.1 running binary S (28) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 7 other builds of this model use the same binary, so you can switch between them in both directions.