SM-P601 1 country
Samsung Galaxy Note 10.1 P601UBUBMJ4 Firmware
Samsung Galaxy Note 10.1 P601UBUBMJ4 is an Android firmware for Peru (SAM). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P601UBSDSA2: bootloader binary raised from S (28) to U (30), so after installing it there is no way back to older builds. A newer build for SM-P601 is available: P601XXUDQA1.
8.8/10 (470)4,327 times
n/a
OS Version
2013-10-14
Build Date
n/a
Security patch
1
Countries
1
CSC codes
U (30)
Bootloader binary
Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: P601UBUBMJ1
Device specifications
- Display diagonal25.6 cm (10.1")
- Display resolution2560 x 1600 pixels
- Rear camera resolution8 MP
- Rear camera typeSingle camera
- Front camera resolution2 MP
- Wi-Fi standardWi-Fi 5 (802.11ac)
- Weight547 g
Specifications of SM-P6010, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.
How to flash P601UBUBMJ4
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- P601UBUBMJ4 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
No. A newer build for SM-P601 is available: P601XXUDQA1. Install it instead of P601UBUBMJ4 unless you need this exact version. The previous build was P601UBSDSA2.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 1.39 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Note 10.1 must be on bootloader binary U (30) or lower.
This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Note 10.1 running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 30 other builds of this model use the same binary, so you can switch between them in both directions.