GT-P6200 1 country Android 3.2 (Honeycomb)

Samsung Galaxy Tab 7.0 Plus P6200JPLP6 Firmware

Name: Samsung Galaxy Tab 7.0 Plus (GT-P6200)
Brand: Samsung
Availability: InStock

Samsung Galaxy Tab 7.0 Plus P6200JPLP6 is an Android 3.2 (Honeycomb) firmware for Saudi Arabia (JED). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P6200JPKL2 https://samfirm.shop/build/P6200JPKL2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for GT-P6200 is available: P6200XXMF1 https://samfirm.shop/build/P6200XXMF1.

9.2/10 (450)4,469 times

Android 3.2 (Honeycomb)

OS Version

n/a

Build Date

n/a

Security patch

Countries

CSC codes

J (19)

Bootloader binary

Bootloader binary J (19). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy Tab 7.0 Plus use bootloader binary X (33) (latest: P6200XXMF1). If your device already runs binary X (33), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: P6200XXLQ1

Model	Region	CSC Version	Size	File name	Download
GT-P6200	JED Saudi Arabia	P6200OJPLP5	—	—

How to flash P6200JPLP6

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

P6200JPLP6 has bootloader binary J (19). Your device must run binary J (19) or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

P6200JPLP6 is Android 3.2 (Honeycomb) firmware for Samsung Galaxy Tab 7.0 Plus, released for Saudi Arabia (JED).

No. A newer build for GT-P6200 is available: P6200XXMF1. Install it instead of P6200JPLP6 unless you need this exact version. The previous build was P6200JPKL2.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Tab 7.0 Plus must be on bootloader binary J (19) or lower.

This build uses bootloader binary J (19). It can be flashed on a Samsung Galaxy Tab 7.0 Plus running binary J (19) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.