GT-P6800 1 country Android 3.2 (Honeycomb)

Samsung Galaxy Tab 7.7 P6800JPLPA Firmware

Name: Samsung Galaxy Tab 7.7 (GT-P6800)
Brand: Samsung
Availability: InStock

Samsung Galaxy Tab 7.7 P6800JPLPA is an Android 3.2 (Honeycomb) firmware for United Arab Emirates (XSG). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build P6800JPKL4, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for GT-P6800 is available: P6800ZSMK1.

8.8/10 (470)4,428 times

Android 3.2 (Honeycomb)

OS Version

2012-11-08

Build Date

n/a

Security patch

Countries

CSC codes

J (19)

Bootloader binary

Bootloader binary J (19). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy Tab 7.7 use bootloader binary Z (35) (latest: P6800ZSMK1). If your device already runs binary Z (35), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: P6800XXLPW

Model	Region	CSC Version	Release date	Size	File name	Download
GT-P6800	XSG United Arab Emirates	P6800OJPLP7	2012-11-30	—	—

How to flash P6800JPLPA

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

P6800JPLPA has bootloader binary J (19). Your device must run binary J (19) or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

P6800JPLPA is Android 3.2 (Honeycomb) firmware for Samsung Galaxy Tab 7.7, released for United Arab Emirates (XSG). Samsung built it on 2012-11-08.

No. A newer build for GT-P6800 is available: P6800ZSMK1. Install it instead of P6800JPLPA unless you need this exact version. The previous build was P6800JPKL4.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Tab 7.7 must be on bootloader binary J (19) or lower.

This build uses bootloader binary J (19). It can be flashed on a Samsung Galaxy Tab 7.7 running binary J (19) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 2 other builds of this model use the same binary, so you can switch between them in both directions.