SM-S367VL 1 country Android 8.0.0

Samsung Galaxy J3 Orbit S367VLUDU2ASA1 Firmware

Name: Samsung Galaxy J3 Orbit (SM-S367VL)
Brand: Samsung
Availability: InStock

Samsung Galaxy J3 Orbit S367VLUDU2ASA1 is an Android 8.0.0 firmware for United States (TFN). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S367VLUDU2ARI3 https://samfirm.shop/build/S367VLUDU2ARI3, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-S367VL is available: S367VLUDS8BTG1 https://samfirm.shop/build/S367VLUDS8BTG1.

8.9/10 (454)4,341 times

Android 8.0.0

OS Version

2019-01-02

Build Date

n/a

Security patch

Countries

CSC codes

Bootloader binary

Bootloader binary 2. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy J3 Orbit use bootloader binary 8 (latest: S367VLUDS8BTG1). If your device already runs binary 8, this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: S367VLUDU2ASA1

Model	Region	CSC Version	Size	File name	Download
SM-S367VL	TFN United States	S367VL2ASA1	—	—

How to flash S367VLUDU2ASA1

Install Samsung USB Drivers:Download Official Drivers
Download Odin Flash Tool:

S367VLUDU2ASA1 has bootloader binary 2. Your device must run binary 2 or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Frequently Asked Questions

S367VLUDU2ASA1 is Android 8.0.0 firmware for Samsung Galaxy J3 Orbit, released for United States (TFN). Samsung built it on 2019-01-02.

No. A newer build for SM-S367VL is available: S367VLUDS8BTG1. Install it instead of S367VLUDU2ASA1 unless you need this exact version. The previous build was S367VLUDU2ARI3.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy J3 Orbit must be on bootloader binary 2 or lower.

This build uses bootloader binary 2. It can be flashed on a Samsung Galaxy J3 Orbit running binary 2 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.