Samsung Galaxy J3 Orbit S367VLUDU3ASC2 Firmware
Samsung Galaxy J3 Orbit S367VLUDU3ASC2 is an Android 8.0.0 firmware for United States (TFN). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S367VLUDU2ASA1: bootloader binary raised from 2 to 3, so after installing it there is no way back to older builds. A newer build for SM-S367VL is available: S367VLUDS8BTG1.
8.9/10 (453)4,243 times
Android 8.0.0
OS Version
2019-03-20
Build Date
n/a
Security patch
1
Countries
1
CSC codes
3
Bootloader binary
Bootloader binary 3. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
Newer builds of Samsung Galaxy J3 Orbit use bootloader binary 8 (latest: S367VLUDS8BTG1). If your device already runs binary 8, this build cannot be flashed.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: S367VLUDU3ASC2
How to flash S367VLUDU3ASC2
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- S367VLUDU3ASC2 has bootloader binary 3. Your device must run binary 3 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
S367VLUDU3ASC2 is Android 8.0.0 firmware for Samsung Galaxy J3 Orbit, released for United States (TFN). Samsung built it on 2019-03-20.
No. A newer build for SM-S367VL is available: S367VLUDS8BTG1. Install it instead of S367VLUDU3ASC2 unless you need this exact version. The previous build was S367VLUDU2ASA1.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy J3 Orbit must be on bootloader binary 3 or lower.
This build uses bootloader binary 3. It can be flashed on a Samsung Galaxy J3 Orbit running binary 3 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary 3.