Samsung Galaxy Ace 3 (Latin) S7270LUBUAMG3
GT-S7270L 1 country

Samsung Galaxy Ace 3 (Latin) S7270LUBUAMG3 Firmware

Samsung Galaxy Ace 3 (Latin) S7270LUBUAMG3 is an Android firmware for Panama (PBS). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S7270LDCANC1: bootloader binary raised from C (12) to U (30), so after installing it there is no way back to older builds. A newer build for GT-S7270L is available: S7270LUBUANG1.

Download firmware
9.0/10 (474)4,387 times
2013-07-29
Build Date
1
Countries
1
CSC codes
U (30)
Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: S7270LUBUAMG2
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    GT-S7270L
    PBS Panama
    		S7270LTFGAMG1 2013-10-22 — —

    No matching downloads

    How to flash S7270LUBUAMG3

    • S7270LUBUAMG3 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    No. A newer build for GT-S7270L is available: S7270LUBUANG1. Install it instead of S7270LUBUAMG3 unless you need this exact version. The previous build was S7270LDCANC1.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Ace 3 (Latin) must be on bootloader binary U (30) or lower.

    This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Ace 3 (Latin) running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 4 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Ace 3 (Latin)

    No changelog details available.
    Model firmware by region