Samsung Galaxy Trend Lite S7390XPUANI1
GT-S7390 1 country Android 4.1.2 (Jelly)

Samsung Galaxy Trend Lite S7390XPUANI1 Firmware

Samsung Galaxy Trend Lite S7390XPUANI1 is an Android 4.1.2 (Jelly) firmware for Portugal (TPH). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S7390XWUANI1: Android updated from Jelly(Android Bean) to Android 4.1.2 (Jelly). A newer build for GT-S7390 is available: S7390XXUAPA1.

Download firmware
9.0/10 (478)4,259 times
Android 4.1.2 (Jelly)
OS Version
2014-09-08
Build Date
1
Countries
1
CSC codes
U (30)
Bootloader binary

Bootloader binary U (30). Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: S7390XPUANI1
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    GT-S7390
    TPH Portugal
    		S7390TPHANI1 2014-10-20 522.947 MiB
    GT-S7390_1_20150519164439_6wo95fm173_fac.zip
    		Download

    No matching downloads

    How to flash S7390XPUANI1

    • S7390XPUANI1 has bootloader binary U (30). Your device must run binary U (30) or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Device specifications

    • Display diagonal10.2 cm (4")
    • Display resolution480 x 800 pixels
    • Display typeTFT
    • Processor frequency1 GHz
    • RAM0.5 GB
    • Rear camera resolution3 MP
    • Rear camera typeSingle camera
    • SIM cardsSingle SIM
    • Battery capacity1500 mAh
    • Weight126 g

    Frequently Asked Questions

    S7390XPUANI1 is Android 4.1.2 (Jelly) firmware for Samsung Galaxy Trend Lite, released for Portugal (TPH). Samsung built it on 2014-09-08.

    No. A newer build for GT-S7390 is available: S7390XXUAPA1. Install it instead of S7390XPUANI1 unless you need this exact version. The previous build was S7390XWUANI1.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 522.947 MiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Trend Lite must be on bootloader binary U (30) or lower.

    This build uses bootloader binary U (30). It can be flashed on a Samsung Galaxy Trend Lite running binary U (30) or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 28 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Trend Lite

    No changelog details available.
    Model firmware by region