SM-S757BL 1 country Android 8.0.0

Samsung Galaxy J7 Crown S757BLUDU1ARL3 Firmware

Samsung Galaxy J7 Crown S757BLUDU1ARL3 is an Android 8.0.0 firmware for United States (TFN). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build S757BLUDU1ARI2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-S757BL is available: S757BLUDS6BTE3.

Download firmware
9.2/10 (462)4,305 times
Android 8.0.0
OS Version
2018-12-28
Build Date
1
Countries
1
CSC codes
1
Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy J7 Crown use bootloader binary 6 (latest: S757BLUDS6BTE3). If your device already runs binary 6, this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: S757BLUDU1ARL3
    ModelRegionCSC VersionSizeFile nameDownload
    SM-S757BL
    TFN United States
    		S757BL1ARL3 — — Download

    No matching downloads

    How to flash S757BLUDU1ARL3

    • S757BLUDU1ARL3 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    S757BLUDU1ARL3 is Android 8.0.0 firmware for Samsung Galaxy J7 Crown, released for United States (TFN). Samsung built it on 2018-12-28.

    No. A newer build for SM-S757BL is available: S757BLUDS6BTE3. Install it instead of S757BLUDU1ARL3 unless you need this exact version. The previous build was S757BLUDU1ARI2.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy J7 Crown must be on bootloader binary 1 or lower.

    This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy J7 Crown running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy J7 Crown

    No changelog details available.
    Model firmware by region