Samsung Galaxy Note9 SC01LOMU1BSG5
SC-01L 1 country Android 9

Samsung Galaxy Note9 SC01LOMU1BSG5 Firmware

Samsung Galaxy Note9 SC01LOMU1BSG5 is an Android 9 firmware for Japan (DCM). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build SC01LOMU1BSF2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SC-01L is available: SC01LOMS1CVK1.

Download firmware
9.2/10 (458)4,369 times
Android 9
OS Version
2019-07-17
Build Date
1
Countries
1
CSC codes
1
Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: SC01LOMU1BSG5
    ModelRegionCSC VersionSizeFile nameDownload
    SC-01L
    DCM Japan
    		SC01L1BSG5 — —

    No matching downloads

    How to flash SC01LOMU1BSG5

    • SC01LOMU1BSG5 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    SC01LOMU1BSG5 is Android 9 firmware for Samsung Galaxy Note9, released for Japan (DCM). Samsung built it on 2019-07-17.

    No. A newer build for SC-01L is available: SC01LOMS1CVK1. Install it instead of SC01LOMU1BSG5 unless you need this exact version. The previous build was SC01LOMU1BSF2.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Note9 must be on bootloader binary 1 or lower.

    This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy Note9 running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 13 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Note9

    No changelog details available.

    · Device stability improvements, bug fixes.
    · New and / or enhanced features.
    · Further improvements to performance.

    No changelog details available.
    Model firmware by region