SCG01 1 country Android 13

Samsung Galaxy S20 5G SCG01KDS1DXB1 Firmware

Samsung Galaxy S20 5G SCG01KDS1DXB1 is an Android 13 firmware for Japan (KDI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build SCG01KDU1DWHA, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. This is the newest build for SCG01.

Download firmware
8.7/10 (95)540 times
Android 13
OS Version
1
Countries
1
CSC codes
1
Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: SCG01KDS1DXB1
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    SCG01
    KDI Japan
    		SCG01QDI1DXB1 2024-03-21 6.573 GiB
    SCG01_5_20240227104541_4i6gc6c2oo_fac.zip
    		Download

    No matching downloads

    How to flash SCG01KDS1DXB1

    • SCG01KDS1DXB1 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    SCG01KDS1DXB1 is Android 13 firmware for Samsung Galaxy S20 5G, released for Japan (KDI).

    Yes. SCG01KDS1DXB1 is the newest build for SCG01 on SamFirm. The previous build was SCG01KDU1DWHA.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 6.573 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy S20 5G must be on bootloader binary 1 or lower.

    This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy S20 5G running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 18 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy S20 5G

    No changelog details available.
    Model firmware by region