SCL22 1 country Android 5.0

Samsung GALAXY Note3 SCL22KDS2GPL1 Firmware

Samsung GALAXY Note3 SCL22KDS2GPL1 is an Android 5.0 firmware for Japan (KDI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build SCL22KDU2GPG2, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. This is the newest build for SCL22.

Download firmware
9.1/10 (457)8,678 times
Android 5.0
OS Version
2016-12-22
Build Date
1
Countries
1
CSC codes
2
Bootloader binary

Bootloader binary 2. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: SCL22KDS2GPL1
    ModelRegionCSC VersionBuild DateRelease dateSizeFile nameDownload
    SCL22
    KDI Japan
    		KDS2GPL12GPL1 2016-12-22 — — —
    SCL22
    KDI Japan
    		SCL22KDI2GPL1 — 2017-02-02 1.466 GiB
    SCL22_2_20170201141213_jopzwxll2k_fac.zip

    No matching downloads

    How to flash SCL22KDS2GPL1

    • SCL22KDS2GPL1 has bootloader binary 2. Your device must run binary 2 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    SCL22KDS2GPL1 is Android 5.0 firmware for Samsung GALAXY Note3, released for Japan (KDI). Samsung built it on 2016-12-22.

    Yes. SCL22KDS2GPL1 is the newest build for SCL22 on SamFirm. The previous build was SCL22KDU2GPG2.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 1.466 GiB; keep about twice that free on the computer to unzip it. The Samsung GALAXY Note3 must be on bootloader binary 2 or lower.

    This build uses bootloader binary 2. It can be flashed on a Samsung GALAXY Note3 running binary 2 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 2 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung GALAXY Note3

    No changelog details available.
    Model firmware by region