SCT21 1 country Android 6.0.1

Samsung GALAXY Tab S SCT21KDU1CPL3 Firmware

Samsung GALAXY Tab S SCT21KDU1CPL3 is an Android 6.0.1 firmware for Japan (KDI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SCT21 is available: SCT21KDU1CQG1.

Download firmware
9.4/10 (34)288 times
Android 6.0.1
OS Version
2016-12-22
Build Date
1
Countries
1
CSC codes
1
Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: SCT21KDU1CPL3
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    SCT21
    KDI Japan
    		SCT21KDI1CPL3 2016-12-26 2.227 GiB
    SCT21_1_20161222194039_oq6ls9jy3d_fac.zip

    No matching downloads

    How to flash SCT21KDU1CPL3

    • SCT21KDU1CPL3 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Frequently Asked Questions

    SCT21KDU1CPL3 is Android 6.0.1 firmware for Samsung GALAXY Tab S, released for Japan (KDI). Samsung built it on 2016-12-22.

    No. A newer build for SCT21 is available: SCT21KDU1CQG1. Install it instead of SCT21KDU1CPL3 unless you need this exact version.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 2.227 GiB; keep about twice that free on the computer to unzip it. The Samsung GALAXY Tab S must be on bootloader binary 1 or lower.

    This build uses bootloader binary 1. It can be flashed on a Samsung GALAXY Tab S running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung GALAXY Tab S

    No changelog details available.
    Model firmware by region