Samsung Galaxy S10+ SCV42KDU1ASDB Firmware
Samsung Galaxy S10+ SCV42KDU1ASDB is an Android 9 (Pie) firmware for Japan (KDI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SCV42 is available: SCV42KDU1DXJ1.
8.9/10 (453)4,371 times
Android 9 (Pie)
OS Version
2019-04-29
Build Date
2019-04-01
Security patch
1
Countries
1
CSC codes
1
Bootloader binary
Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: SCV42KDU1ASDB
What's new in SCV42KDU1ASDB
· The security of your device has been improved.
How to flash SCV42KDU1ASDB
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- SCV42KDU1ASDB has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
SCV42KDU1ASDB is Android 9 (Pie) firmware for Samsung Galaxy S10+, released for Japan (KDI). It includes the 2019-04-01 security patch. Samsung built it on 2019-04-29.
No. A newer build for SCV42 is available: SCV42KDU1DXJ1. Install it instead of SCV42KDU1ASDB unless you need this exact version.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy S10+ must be on bootloader binary 1 or lower.
This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy S10+ running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 17 other builds of this model use the same binary, so you can switch between them in both directions.
Other builds and changelog for Samsung Galaxy S10+
Show 13 older builds
· The security of your device has been improved.