Samsung Galaxy S10+ SCV42KDU1ASG1 Firmware
Samsung Galaxy S10+ SCV42KDU1ASG1 is an Android 9 (Pie) firmware for Japan (KDI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build SCV42KDU1ASF4: Android updated from Android 9 to Android 9 (Pie). A newer build for SCV42 is available: SCV42KDU1DXJ1.
9.4/10 (470)8,593 times
Android 9 (Pie)
OS Version
2019-07-18
First release
other regions until 2019-07-20
n/a
Security patch
1
Countries
1
CSC codes
1
Bootloader binary
Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.
All regional downloads
Pick your region (CSC) to download the matching firmware package.
Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
MODEM/CP Version: SCV42KDU1ASG1
How to flash SCV42KDU1ASG1
- Install Samsung USB Drivers:Download Official Drivers
- Download Odin Flash Tool:
- SCV42KDU1ASG1 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
- CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
- HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
- The Download Mode key combo depends on the model: see all combos.
Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.
Frequently Asked Questions
SCV42KDU1ASG1 is Android 9 (Pie) firmware for Samsung Galaxy S10+, released for Japan (KDI). Samsung built it on 2019-07-18.
No. A newer build for SCV42 is available: SCV42KDU1DXJ1. Install it instead of SCV42KDU1ASG1 unless you need this exact version. The previous build was SCV42KDU1ASF4.
Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 4.703 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy S10+ must be on bootloader binary 1 or lower.
This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy S10+ running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 17 other builds of this model use the same binary, so you can switch between them in both directions.
Other builds and changelog for Samsung Galaxy S10+
Show 13 older builds
No changelog details available.