Samsung Galaxy TabS 10.5 T807VVRS1CPL1
SM-T807V 1 country

Samsung Galaxy TabS 10.5 T807VVRS1CPL1 Firmware

Samsung Galaxy TabS 10.5 T807VVRS1CPL1 is an Android firmware for United States (VZW). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build T807VVRU1CPG6, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-T807V is available: T807VVREANE1.

Download firmware
9.1/10 (27)4,670 times
2016-12-09
First release
other regions until 2016-12-21
1
Countries
1
CSC codes
1
Bootloader binary

Bootloader binary 1. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy TabS 10.5 use bootloader binary E (14) (latest: T807VVREANE1). If your device already runs binary E (14), this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: T807VVRS1CPL1
    ModelRegionCSC VersionBuild DateRelease dateSizeFile nameDownload
    SM-T807V
    VZW United States
    		T807VVZW1CPL1 2016-12-21 2017-01-11 2.022 GiB
    SM-T807V_1_20161221124300_yy6boac7ko_fac.zip
    		Download
    SM-T807V
    VZW United States
    		T807V1CPL1 2016-12-09 — — — Download

    No matching downloads

    How to flash T807VVRS1CPL1

    • T807VVRS1CPL1 has bootloader binary 1. Your device must run binary 1 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Device specifications

    • Launched withAndroid
    • Display diagonal26.7 cm (10.5")
    • Display resolution2560 x 1600 pixels
    • Display technologyOLED
    • Rear camera resolution8 MP
    • Rear camera typeSingle camera
    • Front camera resolution2.1 MP
    • Weight467.20 g

    Frequently Asked Questions

    No. A newer build for SM-T807V is available: T807VVREANE1. Install it instead of T807VVRS1CPL1 unless you need this exact version. The previous build was T807VVRU1CPG6.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 2.022 GiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy TabS 10.5 must be on bootloader binary 1 or lower.

    This build uses bootloader binary 1. It can be flashed on a Samsung Galaxy TabS 10.5 running binary 1 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 1 other build of this model uses the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy TabS 10.5

    No changelog details available.
    Model firmware by region