Samsung Galaxy Young2 G130MUBU0ANI4
SM-G130M 1 country Android 4.4.2 (KitKat)

Samsung Galaxy Young2 G130MUBU0ANI4 Firmware

Samsung Galaxy Young2 G130MUBU0ANI4 is an Android 4.4.2 (KitKat) firmware for Mexico (TMM). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build G130MUBU0ANG8, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-G130M is available: G130MUBS0AQB1.

Download firmware
9.2/10 (457)8,562 times
Android 4.4.2 (KitKat)
OS Version
2014-09-19
Build Date
1
Countries
1
CSC codes
0
Bootloader binary

Bootloader binary 0. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: G130MUBU0ANI4
    ModelRegionCSC VersionRelease dateSizeFile nameDownload
    SM-G130M
    TMM Mexico
    		G130M0ANI5 — — —
    SM-G130M
    TMM Mexico
    		G130MTMM0ANI5 2014-10-13 501.693 MiB
    SM-G130M_1_20170203151253_soagkq4269_fac.zip

    No matching downloads

    How to flash G130MUBU0ANI4

    • G130MUBU0ANI4 has bootloader binary 0. Your device must run binary 0 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Device specifications

    • Display diagonal8.89 cm (3.5")
    • Display resolution320 x 480 pixels
    • Display typeTFT
    • RAM0.5 GB
    • Rear camera resolution3 MP
    • Rear camera typeSingle camera
    • Battery capacity1300 mAh
    • Weight108 g

    Specifications of SM-G130, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.

    Frequently Asked Questions

    G130MUBU0ANI4 is Android 4.4.2 (KitKat) firmware for Samsung Galaxy Young2, released for Mexico (TMM). Samsung built it on 2014-09-19.

    No. A newer build for SM-G130M is available: G130MUBS0AQB1. Install it instead of G130MUBU0ANI4 unless you need this exact version. The previous build was G130MUBU0ANG8.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The download is 501.693 MiB; keep about twice that free on the computer to unzip it. The Samsung Galaxy Young2 must be on bootloader binary 0 or lower.

    This build uses bootloader binary 0. It can be flashed on a Samsung Galaxy Young2 running binary 0 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 15 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Young2

    No changelog details available.
    Model firmware by region