Samsung Galaxy Ace G357MUBU0AOF4
SM-G357M 1 country Android 4.4.2 (KitKat)

Samsung Galaxy Ace G357MUBU0AOF4 Firmware

Samsung Galaxy Ace G357MUBU0AOF4 is an Android 4.4.2 (KitKat) firmware for Argentina (CTI). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build G357MUBU0AOF3, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. A newer build for SM-G357M is available: G357MUBU0AOG2.

Download firmware
8.8/10 (455)4,461 times
Android 4.4.2 (KitKat)
OS Version
1
Countries
1
CSC codes
0
Bootloader binary

Bootloader binary 0. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: G357MUBU0AOF4
    ModelRegionCSC VersionSizeFile nameDownload
    SM-G357M
    CTI Argentina
    		G357MUWA0AOF1 — —

    No matching downloads

    How to flash G357MUBU0AOF4

    • G357MUBU0AOF4 has bootloader binary 0. Your device must run binary 0 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Device specifications

    • Display diagonal10.9 cm (4.3")
    • Display resolution480 x 800 pixels
    • Display typeSAMOLED
    • Processor frequency1.2 GHz
    • RAM1 GB
    • Rear camera resolution5 MP
    • Rear camera typeSingle camera
    • SIM cardsSingle SIM
    • Battery capacity1900 mAh
    • Weight126 g

    Frequently Asked Questions

    G357MUBU0AOF4 is Android 4.4.2 (KitKat) firmware for Samsung Galaxy Ace, released for Argentina (CTI).

    No. A newer build for SM-G357M is available: G357MUBU0AOG2. Install it instead of G357MUBU0AOF4 unless you need this exact version. The previous build was G357MUBU0AOF3.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Ace must be on bootloader binary 0 or lower.

    This build uses bootloader binary 0. It can be flashed on a Samsung Galaxy Ace running binary 0 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 15 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Ace

    No changelog details available.
    Model firmware by region