Samsung Galaxy Core Prime G360PVPS2AQD1
SM-G360P 1 country Android 4.4.4 (KitKat)

Samsung Galaxy Core Prime G360PVPS2AQD1 Firmware

Samsung Galaxy Core Prime G360PVPS2AQD1 is an Android 4.4.4 (KitKat) firmware for United States (SPR). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. Compared with the previous build G360PVPS2AQA1, Android and the bootloader binary are unchanged, so you can switch between the two in both directions. This is the newest build for SM-G360P.

Download firmware
8.9/10 (458)4,368 times
Android 4.4.4 (KitKat)
OS Version
1
Countries
1
CSC codes
2
Bootloader binary

Bootloader binary 2. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.
    MODEM/CP Version: G360PVPS2AQD1
    ModelRegionCSC VersionSizeFile nameDownload
    SM-G360P
    SPR United States
    		G360PSPT2AQD1 — — Download

    No matching downloads

    How to flash G360PVPS2AQD1

    • G360PVPS2AQD1 has bootloader binary 2. Your device must run binary 2 or lower: it is the 5th character from the end of your current build number.
    • CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
    • HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
    • The Download Mode key combo depends on the model: see all combos.
    Full flashing guide
    Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

    Device specifications

    • Launched withAndroid 4.4
    • Display diagonal11.4 cm (4.5")
    • Display resolution480 x 800 pixels
    • Display typeTFT
    • Processor frequency1.2 GHz
    • RAM1 GB
    • Rear camera resolution5 MP
    • Rear camera typeSingle camera
    • SIM cardsSingle SIM
    • Battery capacity2000 mAh
    • Weight130 g

    Frequently Asked Questions

    G360PVPS2AQD1 is Android 4.4.4 (KitKat) firmware for Samsung Galaxy Core Prime, released for United States (SPR).

    Yes. G360PVPS2AQD1 is the newest build for SM-G360P on SamFirm. The previous build was G360PVPS2AQA1.

    Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy Core Prime must be on bootloader binary 2 or lower.

    This build uses bootloader binary 2. It can be flashed on a Samsung Galaxy Core Prime running binary 2 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". 6 other builds of this model use the same binary, so you can switch between them in both directions.

    Other builds and changelog for Samsung Galaxy Core Prime

    No changelog details available.
    Model firmware by region