SM-J415G 1 country Android 8.1.0 (Pie)

Samsung Galaxy J4+ J415GUBU0ARHG Firmware

Name: Samsung Galaxy J4+ (SM-J415G)
Brand: Samsung
Availability: InStock

Samsung Galaxy J4+ J415GUBU0ARHG is an Android 8.1.0 (Pie) firmware for Mexico (MXO). It is the same firmware configured per region and carrier (CSC). Find your country below, verify the file and download for free. A newer build for SM-J415G is available: J415GUBU6BZB2 https://samfirm.shop/build/J415GUBU6BZB2.

Download firmware 8.9/10 (461)4,369 times

Android 8.1.0 (Pie)

OS Version

Countries

CSC codes

Bootloader binary

Bootloader binary 0. Flashing firmware with a lower binary is usually blocked by Samsung anti-rollback.

Newer builds of Samsung Galaxy J4+ use bootloader binary 6 (latest: J415GUBU6BZB2). If your device already runs binary 6, this build cannot be flashed.

All regional downloads

Pick your region (CSC) to download the matching firmware package.

Will it work on my device?

Paste your current build number from Settings > About phone (About tablet) > Software information, or the output of *#1234#.

MODEM/CP Version: J415GUBU0ARHG

Model	Region	CSC Version	Size	File name	Download
SM-J415G	MXO Mexico	J415GOWO0ARHG	—	—	Download

How to flash J415GUBU0ARHG

J415GUBU0ARHG has bootloader binary 0. Your device must run binary 0 or lower: it is the 5th character from the end of your current build number.
CSC: Use CSC for a clean install, to change the region (CSC code), to downgrade or to repair a device that does not boot.
HOME_CSC: Use HOME_CSC to update the same model and region while keeping your data. Back up anyway: a failed update can still require a reset.
The Download Mode key combo depends on the model: see all combos.

Full flashing guide

Beware: Manually flashing firmwares may brick your device. Use it at your own risk and follow our tutorial steps.

Device specifications

Launched withAndroid 8.1
Display diagonal15.2 cm (6")
Display resolution720 x 1480 pixels
Display typeTFT
RAM2 GB
Rear camera resolution13 MP
Rear camera typeSingle camera
Battery capacity3300 mAh
Weight178 g

Specifications of SM-J415F, a regional variant of the same device. Chipset and SIM lines are left out: they can differ by region.

Frequently Asked Questions

J415GUBU0ARHG is Android 8.1.0 (Pie) firmware for Samsung Galaxy J4+, released for Mexico (MXO).

No. A newer build for SM-J415G is available: J415GUBU6BZB2. Install it instead of J415GUBU0ARHG unless you need this exact version.

Download the package for your region (CSC) and unzip it. In Odin, load each file into the slot with the same name: BL, AP, CP (if the package has one) and CSC, or HOME_CSC to keep your data. Odin checks the built-in checksum of every .tar.md5 file before flashing. The Samsung Galaxy J4+ must be on bootloader binary 0 or lower.

This build uses bootloader binary 0. It can be flashed on a Samsung Galaxy J4+ running binary 0 or lower; if the device already has a higher binary, Odin stops with "SW REV CHECK FAIL". No other build of this model uses binary 0.